The MP2110A is used for the research, development, and manufacturing of 10G to 800G multi-channel blocks/devices

All-in-one instrument with built-in BERT and sampling oscilloscope
Capable of simultaneous measurement with up to 4-channel BERT and dual-channel sampling oscilloscope
Fast measurement and high performance shorten test time, improve yield, and reduce equipment investment cost
Sampling Oscilloscope
Approximately 5 seconds to capture 1 million samples, with a sampling rate of up to 250,000 samples/second
Built-in high-sensitivity O/E (-15 dBm, typical, SMF)
High bandwidth: 35 GHz (optical, SMF), 25 GHz (optical, MMF), 40 GHz (electrical)
Low jitter: 200 fs rms (typical)
NRZ and PAM4 signal analysis capability, supporting 53-Gbaud PAM4 analysis
Built-in 26/53 Gbaud clock recovery unit (CRU) for NRZ and PAM4
NRZ jitter component analysis
BERT
Low jitter PPG: 600 fs (typical)
High sensitivity ED: 25 mV (typical)
Built-in PC support for stable and fast measurement
Supported applications: Evaluating the physical layer performance of 10G/50G/100G/200G/400G/800G optical transmission modules, optical cables, and related components used in data centers, core/metro networks, 4G/5G mobile backhaul, and 5G mobile fronthaul
Transmission paths: Ethernet, eCPRI/RoE, CPRI, SDH/SONET, OTN, InfiniBand, Fibre Channel
Optical transceivers/modules: SFP28, QSFP28, CFP2/4/8, SFP56, QSFP56, OSFP, QSFP-DD
Cables: Active Optical Cable (AOC), Direct Attach Cable (DAC)
Devices: TOSA, ROSA, High-Speed Optical Engine, PHY, Driver IC, CPO
The BERTWave MP2110A not only simultaneously measures the bit error rate (BER) of up to 4 channels on the RX side of optical modules but also performs eye pattern mask tests and eye diagram analysis on the Tx side for up to 4 channels simultaneously. Additionally, the MP2110A sampling oscilloscope has a sampling rate of up to 250,000 samples/second (six times faster than the previous generation instrument), enabling faster eye pattern mask tests and eye diagram analysis. It supports NRZ signal mask margin measurement and jitter analysis. It can also analyze PAM4 signals and supports TDECQ measurements up to 53 Gbaud. Using the BERTWave MP2110A to perform BER measurement and eye diagram analysis simultaneously reduces measurement time by 65%.